Government of India
Ministry of Finance
(Department of Revenue)
New Delhi, the 6th September, 2011
Notification No.86/2011-Customs
G.S.R. (E).- Whereas, in the matter of import of Cold-Rolled Flat products of
Stainless Steel of the width of 600 mm up to 1250 mm of all series further
worked then Cold Rolled (cold reduced) with a thickness of up to 4mm,
originating in or exported from China PR, Japan, Korea, European Union, South
Africa, Taiwan, Thailand and USA, (hereinafter referred to as the subject
goods), falling under heading 7219 of the First Schedule of the Custom Tariff
Act, 1975 (51 of 1975), originating in or exported from China PR, EU, Japan,
Korea, South Africa Taiwan, Thailand and USA, (hereinafter referred to as the
subject countries), the Central Government had imposed anti-dumping duty on the
subject goods, vide
notification no. 14/2010-Customs dated 20th February, 2010
published in Gazette of India, Extraordinary part II, Section 3, Sub-section (i)
vide number G.S.R.95 (E), dated the 20th February,2010.
2. Whereas, on the basis of the Final Findings (Mid-Term Review) Notification
No. 15/16/2009- DGAD, dated 8th June, 2011 of the designated authority, in
exercise of the powers conferred by sub-sections (1) and (5) of section 9A of
the said Customs Tariff Act, read with rules 18 and 23 of the Customs Tariff
(Identification, Assessment and Collection of Anti-dumping Duty on Dumped
Articles and for Determination of Injury) Rules, 1995, the Central Government,
hereby makes the following amendments in the notification of the Government of
India in the Ministry of Finance (Department of Revenue), No. 14/2010-Customs,
dated the 20th February,2010, published in the Gazette of India, Extraordinary
vide number G.S.R. 95 (E), dated the 20th February,2010,namely:-
In the said notification, in para 1, after the Table, the following shall be
inserted, namely:-
“(a): Width tolerance of (+) 30mm shall apply to Mill edged, Cold-rolled flat
products of stainless steel of specified width of 1000mm or more but not
exceeding 1250 mm.
(b): Width tolerance of (+)4mm shall apply to Trim edged Cold rolled flat
products of stainless steel of specified width exceeding 1000mm but not
exceeding 1250mm.”
(Raj Kumar Digvijay)
Under Secretary to the Government of India
[354/87 /2009-TRU (Pt.2)]
Note.-The principal notification number 14/2010-Customs, dated the 20th
February, 2010 was published in the Gazette of India, Extraordinary part II,
Section 3, Sub-section (i) vide number G.S.R.95 (E), dated the 20th
February,2010.